Circuit by Stephan Leben - Back EMF Removal by Transistor Lock
Stephan W. Leben, whose ID is "TheGuru2You," posts some really interesting information on the free energy forum. He started with a circuit produced by Alexander Meissner in 1913, shown here:
 |
| Circuit produced by Alexander Meissner in 1913 |
This circuit increases the current of the primary and secondary coils connected at pin C of the transistor. When the voltage increases at the secondary winding, and the current also increases, there is a back electromotive force (Back EMF) on the steel core of the transformer. Immediately, the primary coil is subjected to a Back EMF that causes the current to suddenly decrease.
This leads to the B and E terminals of the transistor being responsible for locking the circuit. Then, Back EMF will charge capacitor C. This is the method of exploiting Back EMF to create free energy.
Adding a capacitor in series with the primary winding is to exploit voltage transients when the circuit is suddenly interrupted.
Thus, there are two oscillations set up by the coil and capacitor: Electrical oscillations at the primary coil and the secondary coil. Adjusting capacitor C will create a resonance phenomenon of the oscillation, causing the voltage to increase significantly.
Stephan states that he has built this circuit and can confirm that it is a self-resonating powering circuit. Once a twelve-volt supply is connected to the input terminals, the transistor switches on, powering the transformer which feeds repeating pulses to the base of the transistor, sustaining the oscillations. The rate of oscillation is governed by the capacitor marked "C" in the circuit diagram above and the coil across which it is connected.
Combination of Alexander Meissner's Circuit and Stephan Leben's Free Energy Transformer
Stephan W. Leben continued to propose upgrading Alexander Meissner's circuit from 1913. This upgrade and improvement aimed to optimize the power of the transformer.
At the C terminal of the transistor, this time, replace the conventional transformer with the Charles Flynn transformer. The primary coil is now responsible for controlling and promoting magnetic flux through the steel core of the transformer.
This flux will affect the primary winding of the Charles Flynn transformer. There is still a BACK EMF phenomenon between the primary winding from terminals E and B of the transistor and the primary winding of the Charles Flynn transformer. The operating process is quite similar to the circuit Alexander Meissner presented in 1913. Thus, to improve and develop the circuit at this time, one must add a capacitor to the primary winding of the Charles Flynn transformer. See diagram:
The transistor stage is self-oscillating as before, the transformer now being made up of the red and blue coil windings. This oscillation also oscillates the Flynn magnetic frame, producing an electrical output via the black coils at each end of the magnetic frame. This is, of course, an oscillating, or AC output, so the four diodes produce a full-wave rectified (pulsating) DC current which is smoothed by the capacitor connected to the diodes.
This circuit would be started by touching a 12 volt source very briefly to the output terminals on the right. An alternative would be to wave a permanent magnet close to the red and blue coils as that generates a voltage in the coils, quite sufficient to start the system oscillating and so, becoming self-sustaining. Stephan suggests using the piezo crystal from a lighter and connecting it to an extra coil to produce the necessary voltage spike when the coil is held close to the blue coil and the lighter mechanism clicked.
A surprising problem would be how to switch the device off since it runs itself. To manage this, Stephan suggests a two-pole On/Off switch to disconnect the output and prevent it supplying the input section of the circuit. To show whether or not the circuit is running, a Light-Emitting Diode ("LED") is connected across the output and the current flowing through it limited by a resistor of about 820 ohms.
Anyone wanting to try replicating this device will need to experiment with the number of turns in each coil and the
wire diameter needed to carry the desired current. Stephan states that you need to have at least twice the weight
of copper in the (black) output coils as there is in the (blue) input coils in order to allow the device produce excess
power. The first page of the Appendix shows the current carrying capacity for each of the standard wire
diameters commonly offered for sale. As this is a fairly recently released circuit, I am not aware of any
replications of it at this time.
Application of Free Energy With Magnets by Stephan Leben and Charles Flynn
As the diagram above shows, according to the theory of Back EMF exploitation, along with the power of the magnet, we see that a 12V battery can create an output power source with high voltage and high current.
The question is: How can a 12V battery be used to power an entire house?
With the above diagram at the output, in the secondary winding of the Charles Flynn transformer, connect it to an inverter to obtain alternating current with the desired voltage and frequency. See the basic diagram:
 |
| Free Energy With Magnets: Stephan Leben and Charles Flynn's transformer are converted into regular electricity. Alternating current (AC) is converted into direct current (DC) |
To be able to store electricity and supply more electrical appliances, we can connect more batteries (battery bank) so that the output of the transformer charges the "battery bank" And from this battery bank, it is connected to the inverter to convert DC power to AC.
 |
| Free Energy With Magnets: Stephan Leben and Charles Flynn's transformer are converted into regular electricity. Alternating current (AC) is converted into direct current (DC) - version connected to battery bank to generate stable power |
۞ Permanent magnets:
- 👉 Magnet Strong Magnetic Rectangular Magnetic Patch 50X20X10 Strong Magnet Neodymium Magnetic Steel Large-size Parcel Post 50 * 20
- Backup link: 👉 Box-shaped permanent magnet
- 👉 UF80B Al4750nH/N2 large power transformer core round size 416mm UU79/129/31 UU transformer ferrite core MnZn PC40 ,7pairs/lot
- Backup link: 👉 UY30 UU Transformer Bobbin Ferrite Core for Appliance Repairing UY95/67/26mm RF Choke Ferrite Bead MnZn PC40 Pack of 2
- Backup link: 👉 Steel core for transformer - Rectangular frame
- Copper wire: 👉 copper wire for transformer
- 10K Resistor: 👉 1/4W Resistance 1% Metal Film Resistor Pack Assorted Kit 1K 10K 100K 220ohm 1M Resistors 300pcs/set + 👉 backup link
- Resistor 100 Ohm: 👉 20pcs 100 ohm 2W 100R Metal film resistor 👉 + backup link
۞ Battery
۞ Inverter
Free Energy With Magnets - Nikola Tesla's Technology
🔹 Version from Nikola Tesla's "Magnifying Transmitter"
🔹 The "tension" for "electricity fractionation" to occur is the Earth's Potential Potential. To be precise, it is the tension of the Ether, and the electricity is the dynamic polarization of the Ether.
🔹 During "Electricity segment", the magnetic field collapses several times in short periods of time. That leads the voltage V = Φ/t to reach infinity (V → ∞) when t → 0
- V - The electromotive force which results from the production or consumption of the total magnetic induction Φ (Phi). The unit is the “Volt”. Where t is the time of magnetic field collapse from maximum to complete collapse.
- Research scholars also call it Tesla's technology called Radiant Energy from Electronic Circuits, Impulse Technology.
- 🔹 Radiant energy
- 🔹 AC generator - Free Energy
🔹 Tesla Technology and "Free Energy" in practical application